CURRENT_EXPERIMENT_NAME "AgBehLaB6"
                      
    # This file runs USAXS, SAXS and WAXS scans according to the syntax shown below
    #       
    # Scan Type      sx         sy   Thickness  Sample Name
    # ------------------------------------------------------  
    # USAXSscan    45.07       98.3     0      "Water Blank"
    # saxsExp      45.07       98.3     0      "Water Blank"
    # waxsExp      45.07       98.3     0      "Water Blank"  
    #      Use a space (not a tab) to separate arguments (i.e., 45.07 <space> 98.3 in the examples above)  

    # Run this file by typing the following command in the spec window:   USAXS> CollectData usaxs.mac              
                                    
    # Stop the run using the "Stop after this scan?" checkbox in USAXS user main intf and waiting until the USAXS> prompt reappears
              
    ############ PLACE ALL USER COMMANDS AFTER THIS LINE ############                

          #SAXS measurements
    
          saxsExp     20.000     20.000    1    "AgBehenateLaB6"

          #End of SAXS, next is WAXS  

          waxsExp     20.000     20.000    1    "AgBehenateLaB6"